MN9-300: 9′ x 9′ Column and Boom Welding Manipulator
Load Capacity (at boom end): 500 lbs Boom Stroke: 108" Column Stroke: 96" Boom Traverse Speed Range: 5–120 in/min Mast Traverse Speed Range: 5–120 in/min Travel Car Speed: 5–120 in/min Power Requirements: 480 V, 3-ph Equipment Mass: Variable
Welding Power Source Options: Submerged Arc (SAW), MIG, or to customer specification
Input Power Options: as per standard spec or to customer requirements
Upgrade Controls: full integration to LJ welding positioners or turning rolls through HMI touchscreens and master PLC
Customizable with full integration capabilities for most existing mainstream welding equipment
Column and Boom Manipulator CAMERA SYSTEMS
The Xiris XVC-O Weld Camera monitors and records all open arc welding processes including MIG, MAG, TIG, Plasma, Laser and Stick welding.
Processes can be viewed remotely (40 m / 130 ft. away), providing live images of the torch, weld area and material during standard and high-power welding conditions.
The XVC-S Weld Camera provides a real-time view of the sub arc welding process from ground level.
Housed in a rugged enclosure the XVC-S, features single or dual crosshairs, can act as a set-up tool to position the welding torch or provide a means to adjust the welding position or parameters during the process.
Column & Boom Welding Manipulator SEAM TRACKING
ISLS-on-Spiral-OD-1200x891.jpgn laser vision tracking, a laser sensor is positioned a short distance ahead of the welding torch.
Before column boom welding begins, the sensor will search for a feature, the weld seam for example, and make two or three measurements to identify position and orientation.
Triangulation is used for measurements therefore some kind of physical feature is needed for the laser sensor to take measurements.
In boom-and-column welding, a physical feature can be a gap, mismatch, an edge, etc.and depending on the sensor, even very small features (around 0.2mm) can be tracked.
A comparison is made between the measured position of the feature and a pre-taught position and if there is a difference, correction co-ordinates are sent to the slides or to the controller positioning the robot to place the weld manipulators torch correctly at the start of and during welding.
This results in welds of higher quality that are always in the right place.
Column and Boom Manipulator Power Sources
Any style of welding head including SAW, FCAW, CMT, MIG, or other; integrated with Lincoln, Miller or Fronius.
FLUX Recovery SYSTEMS For Column and Boom Welding Manipulators
For all submerged arc processes, flux delivery, recovery, and heating (drying) options available to customer requirement.
Manual or powered track drive.
CROSS SLIDES For Column & Boom Manipulators
Fully programmable oscillator, compact/small bore, or regular powered 6″”x6″” cross-slides.Download product catalogue
Too Many Options? Do you need help choosing the right machine?
Send us an Email and let us know about your project and we will provide you with the best options available.
Or you can Call Us on (+61) 1300 62 4020